Monolith Bed Guide

Tools you will need:

Drill (Highly recommended)
Friend/Helper (Highly recommended)

Note: reference the photos online at the link below to see the general structure and shape.

The Monolith Live Edge Bed

Headboard Assembly Guide

Locate all of your pieces
1. 1 Large Wood Headboard
2. 2 Floating Nightstands
3. 1 Headboard Hardware Bag
Position the headboard up against the wall you want it to go against. Have a friend hold it for extra safety.
Slide the nightstands down onto the French Cleat. They should feel fairly secure.
For extra security on the nightstands, apply 2 screws at 2.5" each into the backs of the headboard. There are pre-drilled holes which will tighten the nightstands against the headboard. Do not over tighten

The Bed Frame

Step 1:

- Begin by clearing a large area to do the assembly in. (You’ll need the space.)

Step 2:

- Locate all 2 side rails and 1 front rail.

- Each is marked in the joint with an "L" or "R". If you are standing at the foot of the bed and looking at the headboard, L marks the left side and R marks the right side. Layout the Left side rail on the left and the Right side rail on the right.

- Get 2 boulders in position at the ends of the side rails. Make sure the deep cutout portion faces inwards towards the frame. They should be cut to the same dimensions, so either should work on either side.

- Slide the side rail into the boulder.

- Locate the side rail metal brackets at the ends of the side rails. (Add the threaded screws if they are not already added.) Slide the metal brackets from the side rails down into the metal brackets on the headboard.

- Slide down the front rail into the boulders. They should line up with the joints on the boulders AND the joints on the side rails. You might need to adjust the positioning of the boulders and side rails to get a good fit.

- Tighten up the metal brackets via the 2 large screws on either side.

Step 3:

Gather your slats. Find the one marked #1 and your last one. (Your last slat is typically #7 for King/Queen and #8 for a Cali King bed, but do check.) Install slat #1 and your last slat. The slat marked #1 should go right up against the edge of the footboard and your last slat should go right up against the back (there are black lines to help you line them up with the pre-drilled holes). Install slat #7 using 1.25” screws to install into the pre-drilled holes. Note: Slat #1 doesn't get screwed down because it sits atop the boulders.

- Assemble center support beam by attaching 2x4 legs to it using the 2.5” screws provided. If center support beam legs are already attached, move on to next step.

- Install center support beam by sliding it underneath the two slats already installed. Position it down the center of the bed, and attach it to the slats. Use 2 of the 2.5” screws provided (1 at each end using the pre-drilled holes).

- Locate the other slats. The slats are numbered and the side rails are marked with lines for where to attach them. Attach the slats to the frame using the 1.25” screws sent with the bed.

Please contact us if you need any help!

marcus@dannerfurniture.com